Rocky Mountain Club B5

Discussion Forums => Modifications => Topic started by: Wyaka on June 27, 2005, 07:32:17 PM

Title: Wheel shops
Post by: Wyaka on June 27, 2005, 07:32:17 PM
Does anyone know of a good wheel shop that can drill wheel bolt holes to a larger size and not cost an arm and a leg? I got ahold of a set of 4 2002 Mercedes C230 Kompressor 16 inch wheels and the bolt holes are too small for the stock VW bolts. The wheels are immaculate, offset is 37, bolt pattern is 5 X 112, no curb rash and the tires have only 1000 miles on them, which leads me back to my original problem...bolt holes are too small. Any reccomendations would be helpful.
Title: Wheel shops
Post by: ianacole on June 27, 2005, 08:19:33 PM
If worse comes to worst, don't they make offset studs?  14mm for the hub and 12mm (or whatever fits the rim) on the rim side?
Title: Wheel shops
Post by: TurboDub on June 27, 2005, 09:22:15 PM
I'm not sure, but I think this place advertises as a "full service" shop

Performance Wheel & Tire
4095 S. Santa Fe Dr, Sheridan, CO 80110
Phone: 303-934-2929 - Fax: 303-761-4957
info@performancewheel.com

http://www.performancewheel.com/index.cfm
Title: Wheel shops
Post by: jayryan on June 28, 2005, 05:06:20 AM
Woody's Wheels just off of Santa Fe should have no problem hooking you up with that.